Instruction Manual
Table Of Contents
- 1. General
- 2. Installation
- 2.1 Installing power source mains plug
- 2.2 Installing cooling unit (optional)
- 2.3 Installing equipment on cart (optional)
- 2.4 Connecting welding gun
- 2.5 Installing earth return cable
- 2.6 Installing remote control (optional)
- 2.7 Installing and replacing feed rolls
- 2.8 Installing and replacing wire guide tubes
- 2.9 Installing and changing wire
- 2.10 Installing gas bottle and testing gas flow
- 2.11 How to get welding programs
- 3. Operation
- 3.1 Preparing welding system for use
- 3.2 Calibrating welding cable
- 3.3 Using control panel
- 3.3.1 Control panel: Home view
- 3.3.2 Control panel: Weld Assist
- 3.3.3 Control panel: Channels
- 3.3.4 Control panel: WPS view
- 3.3.5 Control panel: Welding parameters
- 3.3.6 Control panel: Weld history
- 3.3.7 Control panel: Info view
- 3.3.8 Control panel: Device settings
- 3.3.9 Control panel: Applying welding programs
- 3.3.10 Control panel: Weld data view
- 3.4 Additional guidance to functions and features
- 3.5 Pulse welding
- 3.6 Wireless connection (WLAN)
- 3.7 Using remote control
- 3.8 Changing welding polarity
- 3.9 Lifting equipment
- 4. Maintenance
- 5. Technical data
Master M 358
Operating manual - EN
3.7 Using remote control
Remote control HR43
To adjust the wire feed speed, turn the knob on the remote control.
To change the memory channel instead of the wire feed speed with the remote, change the remote mode setting in the
"Control panel: Device settings" on page51.
Remote control HR40
To adjust the welding parameters, turn the knobs on the remote control.
In the automatic 1-MIG mode the HR40 control knob functions are defined by the selected 1-MIG process and reflect the
adjustments of the control panel's two control knobs.
In the manual MIG mode the adjustments on the remote control as well as the minimum and maximum values for the
adjusted parameters can be set in the control panel settings ("Control panel: Device settings" on page51).
With HR40 remote control, the minimum and maximum values affect also the resolution of the remote control
adjustment.
© Kemppi
66
1921980 / 2242