Instruction Manual
Table Of Contents
- 1. General
- 2. Installation
- 2.1 Installing power source mains plug
- 2.2 Installing cooling unit (optional)
- 2.3 Installing equipment on cart (optional)
- 2.4 Connecting welding gun
- 2.5 Installing earth return cable
- 2.6 Installing remote control (optional)
- 2.7 Installing and replacing feed rolls
- 2.8 Installing and replacing wire guide tubes
- 2.9 Installing and changing wire
- 2.10 Installing gas bottle and testing gas flow
- 2.11 How to get welding programs
- 3. Operation
- 3.1 Preparing welding system for use
- 3.2 Calibrating welding cable
- 3.3 Using control panel
- 3.3.1 Control panel: Home view
- 3.3.2 Control panel: Weld Assist
- 3.3.3 Control panel: Channels
- 3.3.4 Control panel: WPS view
- 3.3.5 Control panel: Welding parameters
- 3.3.6 Control panel: Weld history
- 3.3.7 Control panel: Info view
- 3.3.8 Control panel: Device settings
- 3.3.9 Control panel: Applying welding programs
- 3.3.10 Control panel: Weld data view
- 3.4 Additional guidance to functions and features
- 3.5 Pulse welding
- 3.6 Wireless connection (WLAN)
- 3.7 Using remote control
- 3.8 Changing welding polarity
- 3.9 Lifting equipment
- 4. Maintenance
- 5. Technical data
Master M 358
Operating manual - EN
The amount of available memory channels differs between different operation modes: MIG (100 channels), TIG (10 chan-
nels) and MMA (10 channels).
The operation mode set in the control panel Settings determines for which main welding process the memory chan-
nels are shown.
Changing memory channel
Turn the right control knob to highlight the desired memory channel. The highlighted memory channel is automatically
activated.
Managing memory channels
The memory channels are managed through the Actions menu.
1. Enter the actions menu by pressing the right control knob.
2. Turn the control knob to highlight the desired action.
3. Select the action by pressing the right control knob.
4. Make further selections as required.
Available actions are:
• Save changes: Save changes to the currently selected channel
• Save to...: Save the current settings to another channel
• Delete:Delete the currently selected channel
• Link to WPS: Link the currently selected channel to a weld pass on a digital welding procedure specification
(dWPS) document.
• Create channel:Create a new channel based on the welding program(s)
>> MIG only:Welding programs can be filtered by base material, wire material, wire diameter, shielding gas and
process. For more information, refer to "Control panel: Applying welding programs" on page53.
• Create from programs:Create new channels based on all of the unused welding programs available (in MIG mode
only)
• Delete all:Delete all channels.
The skewed channel number in the top left corner of the channel selection indicates that the set welding parameters are
different from the ones currently saved on the active memory channel:
© Kemppi
40
1921980 / 2242