Instruction Manual
Table Of Contents
- 1. General
- 2. Installation
- 2.1 Installing power source mains plug
- 2.2 Installing cooling unit (optional)
- 2.3 Installing equipment on cart (optional)
- 2.4 Connecting welding gun
- 2.5 Installing earth return cable
- 2.6 Installing remote control (optional)
- 2.7 Installing and replacing feed rolls
- 2.8 Installing and replacing wire guide tubes
- 2.9 Installing and changing wire
- 2.10 Installing gas bottle and testing gas flow
- 2.11 How to get welding programs
- 3. Operation
- 3.1 Preparing welding system for use
- 3.2 Calibrating welding cable
- 3.3 Using control panel
- 3.3.1 Control panel: Home view
- 3.3.2 Control panel: Weld Assist
- 3.3.3 Control panel: Channels
- 3.3.4 Control panel: WPS view
- 3.3.5 Control panel: Welding parameters
- 3.3.6 Control panel: Weld history
- 3.3.7 Control panel: Info view
- 3.3.8 Control panel: Device settings
- 3.3.9 Control panel: Applying welding programs
- 3.3.10 Control panel: Weld data view
- 3.4 Additional guidance to functions and features
- 3.5 Pulse welding
- 3.6 Wireless connection (WLAN)
- 3.7 Using remote control
- 3.8 Changing welding polarity
- 3.9 Lifting equipment
- 4. Maintenance
- 5. Technical data
Master M 358
Operating manual - EN
2.11 How to get welding programs
The Master M 358 device comes with a welding program work pack preinstalled. These work pack versions cover the
basic welding tasks with the automatic 1-MIG and pulsed welding process.
The additional welding programs, Wise features (WiseSteel, WiseFusion, WisePenetration+) and MAX processes (MAX
Cool, MAX Position, MAX Speed) are installed at the time of purchase according to your specific welding requirements.
This can be done by your local Kemppi dealer. Welding programs can also be added later on.
For more information on the available welding program options and installing the welding programs or software
updates, contact your local Kemppi dealer or go to
Kemppi.com.
The manual MIG process doesn't require additional welding programs.
For applying the welding programs installed on your Master M 358 equipment, refer to "Control panel: Applying welding
programs" on page53.
The list of installed welding programs on your equipment can be seen in the control panel's Info view under Welding
software.
The welding programs included in the Master M 358 work packs are shown here: "Welding program work packs" on
page90.
© Kemppi
31
1921980 / 2242