Operation Manual

2. USE

2.1 POWER SOURCE

2.1.1 Power source components

A11

A12

A10

1 2 3 4

1 Robot Control

2 Wire Feeder

3 Throughput

4 Analog

A1 Control panel

A2 Main switch

A3 Signal light (I/O)

A4 Thermal warning light

A5 Welding cable connection (parallel)

A6 Earthing cable connection

A7 Control cable connection (parallel)

A8 Cooling unit

A9 Mains cable

A10 Fuse for control cable connection (6.3 A slow)

A11 Fan grill

A12 Transportation handles

2.1.2 Positioning of the machine

Place the machine on a rm, dry and level surface. Where possible, do not allow dust or other

impurities to enter the machines cooling air ow. Preferably site the machine above oor level;

for example on a suitable carriage unit.

Notes for positioning the machine

• The surface inclination should not exceed 15 degrees.

• Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in

front of and behind the machine for cooling air to circulate.

• Protect the machine against heavy rain and direct sunshine.

NOTE! The machine should not be operated in the rain as the protection class of the machine,

IP23S, allows for outside preserving and storage only.

NOTE! Never aim metallic grinding spray/sparks towards the equipment.