Operation Manual

Synergetic MIG welding parameters and their values

Name of

parameter

Name

displayed

Parameter values Factory setting Description

Creep Start Level Cre 10 ... 170 % 50 % Percentage of wire feed speed, 10% refers

to slow start, 170% to accelerated start

Hot Start Level Hot -50 ... 75 % 30 % Percent of welding power: -50% refers to

cold start and +75% to hot start

Crater Fill Level CrL 10 ... 90 % 30 % The crater ll level, 10% is the lowest

power and 90% the greatest one, relative to

welding power (preset value).

Post Current Time PoC -9 ... +9 0 Post-welding current time

Synergic MIG Unit Unl m/min, mm, A m/min In synergic welding, the parameter shown

in the left-hand side display (wire feed

speed/plate thickness/average current).

Parameters common to all MIG processes and their values

Name of

parameter

Name

displayed

Parameter values Factory setting Description

Cable

Compensation

CAL -5.0 ... 9.0 V/100 A 1.0 V/100 A Cable compensation (MIG) for voltage

losses.

Code Entry Cod ---, Ent --- Entry of additional features, see page 14.

Restore Factory

Settings

FAC OFF, PAn, All OFF Restores factory settings if you select ON

and exit the menu.

Scaling SCA 0 ... 5000 0 A coecient with which the values in the

welding machine are scaled to the scale

used by the robot.

Checking the parameters in the MEMORY ON state

You can check parameter values in the MEMORY ON state by pressing the button of the

parameter you want. The parameter value will be shown in the display. You cannot modify

parameter values in the MEMORY ON state.

2.3 WIRE FEEDER

Wire guide adapter

The welding wire is taken to the wire feeder through a metallic wire guide adapter. Push the

wire guide to the end of the adapter and screw in with the top xing locks. Attach a spring at

the end of the adapter to serve as the bend support for the wire guide and to prevent the wire

from bending too heavily. Fix the support spring with the bottom xing locks.