Operation Manual

Specifying the SETUP settings for additional features

To set the values of the functional parameters for additional MIG features, use either the

SETUP feature in the control panel (see 2.2.12 "SETUP functions in the control panel") or the

QUICK SETUP feature, which you can activate by pressing the QUICK SETUP button, P8.

Select the parameter to adjust using the left-hand side control knob P11 or the button P10

and then set the parameter value with the right-hand side control know P13. The value

you specied is instantly stored in the control panel memory. The following table lists the

parameter values that can be specied for additional MIG features.

Name of

parameter

Name

displayed

Parameter values Factory setting Description

Creep Start Level

Cre 10 ... 170 % 50 % Percent of wire feed

speed default

10% refers to slow start,

170% refers to fast start

Hot Start Level

Hot -50 ... 75 % 30 % Percent of welding power:

-50% refers to cold start

+75% refers to hot start

Hot Start Time

H2t 0 ... 9.9 s 1.2 s The duration of the hot start in

seconds.

Crater Fill Start

Level

CrS 10 ... 90 % 90 % The welding power at the

beginning of the crater ll stage as

a percentage of the welding power

preset value.

Crater Fill End

Level

CrL 10 ... 90 % 30 % The welding power at the end of

the crater ll stage as a percentage

of the welding power preset value.

Crater Fill Time

Crt 0 ... 9.9 s 2 s The duration of the crater ll stage

in seconds.

NOTE! In crater ll, the initial value of the welding power must be greater than the nal value,

and therefore the adjustment ranges for the initial and nal values are restricted automatically, if

necessary.

Welding Level

Crater Fill Start Level

Crater Fill Time

Crater Fill End Level