Operation Manual

FastMig X 350MV
14
EN
4.3 Welding parameters
MIG
WFSpeed
0.7…25 m/min Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed < 5 m/min, and
by 0.1, when WFSpeed > 5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
Voltage
8…50 V Step: 0.1 Controls the length of the arc
VoltageMax
Sets the limit for maximum voltage value
VoltageMin
Sets the limit for minimum voltage value
Dynamics
-9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
1-MIG
WFSpeed
0.7…25 m/min * Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed < 5 m/min, and
by 0.1, when WFSpeed > 5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
FineTuning
-9.0…+9.0 Factory setting is 0.0
( = curve point)
Adjusts the arc voltage of the curve (arc length) within
certain limits
FineTuningMax
-9.0…+9.0 Step: 0.5 Sets the limit for maximum arc length
FineTuningMin
-9.0…+9.0 Step: 0.5 Sets the limit for minimum arc length
Dynamics
-9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
PULSE MIG
WFSpeed
0.7…25 m/min * Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed
< 5 m/min, and by 0.1, when WFSpeed > 5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
FineTuning
-9.0…+9.0 Factory setting is 0.0
( = curve point)
Adjusts the base current of the curve (arc length) in
certain limits
FineTuningMax
-9.0…+9.0 Step: 0.5 Sets the limit for maximum arc length
FineTuningMin
-9.0…+9.0 Step: 0.5 Sets the limit for minimum arc length
Dynamics
-9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The lower
the value the softer the arc is. The higher the value the
rougher the arc is.
Pulse Current
-10…+15% Factory setting is
0 %
Reduces (–) or raises (+) the pulse current of the curve