Operation Manual

9
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
2. INSTALLATION
2.1 Controller connections
A
E
B
H
I
J
K
C
G
D
F
All controller connections are located on the rear of the
controller unit:
A. Power ON/OFF
B. Sensing cable to workpiece (WORK)
C. Sensing cable to weld head (TORCH)
D. Pendant control cable
E. Weld head control cable
F. Cooling hoses
G. Gas Out (to weld head)
H. Gas In (from cylinder)
I. Welding power connector ( – )
J. Earth return connector ( + )
K. Resettable fuses
TRVL = travel motor, WIRE = Wire feed motor,
OSC = oscillation (weave), AGC = Automatic gap
control
A
B
D
C
The front of the controller unit:
A. Equipment Stop
B. Printer
C. Remote control in holder
D. Water cooler lling hole