Operation Manual

59
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
6.4 Printer operation and maintenance
The printer is mounted in the front panel of the controller
unit allowing program parameters and other data to be
printed. The printouts will remain stable for ve (5) years,
and they are suitable for archival purposes if they are
suitably stored. This printer uses Thermal Paper SP800692.
6.4.1 Installing paper in the printer
To install paper in the printer, do the following:
1. Open the hinged plastic cover over the paper roll.
2. Remove the empty roll.
3. Replace with a new roll oriented so that the paper
is feeding o the bottom of the roll.
4. Lower the plastic cover until it “clicks”.
6.4.2 Cleaning the printer
• The surface of the printer can be cleaned using
a soft dry cloth or a soft cloth with a neutral
detergent.
• Do not clean using any solvents.
• Never wet the inside of the printer.
6.5 Service Workshop maintenance
Kemppi Service Workshops complete maintenance
according to their Kemppi service agreement.
The major points in the maintenance procedure are listed
as follows:
• Cleaning of the machine
• Checking and maintenance of the welding tools
• Checking of connectors, switches and
potentiometers
• Checking of electric connections
• Checking of mains cable and plug
• Damaged parts or parts in bad condition are
replaced by new ones
• Maintenance testing.
• Operation and performance values of the
machine are checked, and when necessary
adjusted by means of software and test
equipment.
Software loading
Kemppi Service Workshops can also test and load rmware
and welding software.