Operation Manual
53
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
5.5 Checking machine setup during booting
1. Master RCM3209 Set Fail Master Rabbit is RCM3200 in controller; change and try again.
2. Master RCM3200 Set Fail Master Rabbit is RCM3209 in controller; change and try again.
3. Not applicable
4. Not applicable
5. Wrong S2 BEMF Driver board Remote conguration is BEMF & ENCODER; change and try again.
6. Wrong S2 BEMF Driver board Remote conguration is ENCODER; change and try again.
7. Wrong S2 BEMF & ENCODER Driver board Remote conguration is BEMF; change and try again.
8. Wrong S2 ENCODER Driver board Remote conguration is BEMF; change and try again.
9. Data Load Failure Check and set weld counter.
10. Data Load Failure Language was reset to English; reselect language.
11. Data Load Failure Calibration record was reset; contact Kemppi for support.
12. Data Load Failure Calibration was reset; run travel and wire calibration again.
13. Data Load Failure Test mode, unit or print set was reset; go to Option and Print Weld to
check again.
14. Default Head Change The default weld head was reset to D Head; press Next to continue.
15. Data Load Failure Machine SN was reset to default; contact Kemppi for support.
16. Data Load Failure Machine Data is reset to default; contact Kemppi for support.
17. Weld Counter Failure Reboot machine and try again.
18. Wrong Arc Strike Method Reboot machine and try again.