Operation Manual

51
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
Comment: xxx/### is maximum OSC speed for the selected weld head.
25. New Weld Creation OSC Speed must be greater than xxxIPS (### mm/m).
Comment: xxx/### is maximum OSC speed for the selected weld head.
26. Copying Weld Failure Weld on USB can’t copied to protection zone directly.
Comment: user sets protection zone for the weld program.
27. Weld Counter Failure Weld counter save fails; go back to try again (ECU01).
Comment: or ECU02
28. Language Save Failure Language save fails; go back to try again (S01).
Comment: save language option, code could be S02.
29. Language Change Language has changed; reboot machine.
30. Password Set Failure Weld protection enabled; user password cannot be
set.
Comment: weld password protection mode
31. Data Save Failure Calibration save fails; go back to save again (ECA01).
Comment: travel or wire calibration, code ECA02 for backup le
32. Program Failure Failure to save weld program under teach mode.
Comment: teach mode, save weld.
33. Not applicable
34. Operating Mode Change Fail BEMF Mode is not supported for Slave2; go back to
change selection.
Comment: Emergency mode for version 1.88 ~1.92
35. Data Save Failure Data save failure ESL02; go back to Main menu and
try again.
Comment: save options
36. Operating Mode Change Operating mode has changed; reboot the machine.
Comment: BEMF or Encoder mode
37. Weld Number xxx Pass
Maintenance Error
You cannot add and delete at the same time.