Operation Manual
38
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
3.8 Editing a weld program
To select weld number to edit:
1. Move cursor to Edit. Press Select.
2. Edit weld parameters. Use cursor to select an item.
Modify with the control knob.
Certain items may not be modied. The cursor will pass
these items.
3. Use Next to move through levels, editing them as
you go.
4. Use Enter to copy one level parameters to the next,
but remember that you will override the original
parameters.
To add/remove a pass:
In Edit mode, proceed to the nal pass/level. The next
screen allows a pass to be added or removed anywhere
in the program.
To save weld/next weld:
The edited weld will overwrite the original program if the
same Weld Number is selected. To create a new program,
select an unused program number.
To scale a weld:
Welds may be edited by scaling current or travel speed
up/down by a percentage of programmed speed. This will
scale programmed values in all passes and levels.