Operation Manual
32
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
Override Limit
You may override any of the pre-programmed values,
but only within the limits that may be dened during
programming.
• You can individually program the percentage
of override limits for each parameter between
0–100% of the programmed value.
• You may obtain sucient override capacity to
compensate for tube t variations, for example,
but avoid modifying the original program outside
of specied heat input limitations.
• The override limits are saved with each weld to
allow dierent override values based on which a
weld is being run.
Use cursor to select line, control knob to modify.
Weld Notes
Use cursor to select line, control knob to modify.
Certain items have been previously selected and
cannot be changed (e.g. Weld No, Data, OD). The cursor will
pass these items.
Program Notes
1. Use cursor to select the line for additional notes.
2. Save if all program selections have been completed
(or use Back to make corrections).
Completion of programming
3. Press Main to exit the Main Menu.
Autoprogram for the 150-series weld heads operates
similarly to the 300-series weld heads. The main dierence
is that programming is time-based and each program is
created on 4 levels.
4. The system automatically creates a new program.
To create a new program manually:
1. Select No.
2. Enter all parameters manually.
Autoprogram is designed only for predened J grooves.
1. To complete programming, press Main to exit to
Main Menu.