Operation Manual

14
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
2.5 Mounting the weld head
1
2
3
1. Place the weld head on top of the pipe.
2. Aim the guide rollers over guide ring and leave the
roller chain and tensioner hanging down to one
side.
3. Rock the machine lightly to ensure that drive
sprocket is properly meshed with the chain.
4
5
6
4. Hold the weld head in its position and pull the
tensioner and latch assembly to the mating
attachment.
5. Check that all guide rollers and chain rollers are in
place and the guide rollers are properly in place.
6. Adjust tensioner length as required and tighten
with moderate nger force only.