Operation Manual

A7 TIG Orbital System 150© Kemppi Oy 2016 1615

OPERATING MANUAL

3.7 Weld head control panel

W009315

A. Stop: immediately terminate the weld cycle and all

functions of the weld head.

B. Start Weld: initiate the weld program. LED light

beside the button is lit during the weld cycle. This is

also a soft way to stop welding.

C. Home position: welding can be started only when

the rotor gear is in its home position. It also allows

easy installation and removal of the workpiece.

1. Press the Home button to move the rotor gear

to the home position.

2. A red LED ignites next to this button, when the

rotor gear reaches its home position.

D. Rotation forward or reverse: with these buttons you

can move the rotor gear to either direction when

welding arc is not on. This is useful when mounting

or replacing the electrode or checking its condition.

3.8 Controller unit control panel

A. Color LCD display: shows the setup values,

parameters and the soft key functions.

B. Stop: terminates the weld cycle and all weld head

functions.

C. Start Weld/Start Downslope: starts welding or

initiates downslope if welding is in progress.

D. USB port: connect memory stick to back up

programs and copy them from one power source

to another, to download QC programs, and to save

welding parameters and print them on a PC.

E. Cursor up: highlight the item above on display.

F. Cursor down: highlight the item below on display.

G. Enter: activate the highlighted item.

H. Control knob: increase/decrease the value of the

selected item.

I. Soft keys (4): select menu items shown on the

display depending on the operation mode (Setup,

Programming, Operation etc.)