Operation Manual
19
Robot Gun Mount T3© Kemppi Oy 2016 1712
OPERATING MANUAL
16. REMOVING THE MOUNT
This section describes how to remove robot mount T3.
Unmounting may only be carried out by specialist personnel. Please make sure
that the shutdown procedures are strictly observed before the unmounting work
begins. Ensure this also for the components integrated into the welding system.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
Removal from operation depends on the type of welding gun. Please observe the
operating instructions of the A7 MIG Gun 500-g or the A7 MIG Gun 500-w welding
guns, as appropriate.
Proceed as follows:
1. Disconnect the hose assembly from the wire feeder.
2. Open the lock ring, and unscrew the fastening screw. See Section 11.3.
3. Pull out the hose assembly.
4. Disconnect the gun neck, and remove it. See sections 11.4 and 11.5.
16.1 Disposal
For disposal, the locally applicable regulations, laws, provisions, standards, and
guidelines must be observed. For the welding torch system to be properly disposed
of, it must be unmounted rst.
16.2 Materials
This product consists for the most part of plastics, steel, and non-ferrous metals. Steel
and non-ferrous metals can be melted down, so iron products are almost innitely
recyclable. The plastic materials used are marked in preparation for appropriate
sorting of the materials for later recycling.
16.3 Consumables
Oils, greases, and cleaning agents must not contaminate the ground or enter the
sewer system. These materials must be stored, transported, and disposed of in suitable
containers. Please observe the relevant local regulations and the disposal instructions
on the safety data sheets supplied by the manufacturer of the consumables. Also,
contaminated cleaning tools (brushes, rags, etc.) must be disposed of in accordance
with the information provided by the manufacturer of the consumables.
16.4 Packaging
The shipping packaging has been reduced to a minimum. Packaging materials are
always selected with attention to their recyclability.