Operation Manual

16
Robot Gun Mount T3© Kemppi Oy 2016 1712
OPERATING MANUAL
14.1 Cleaning robot mount T3 with A7 MIG Gun 500-g
This section describes how to clean the robot mount with A7 MIG Gun 500-g.
Figure 10: Cleaning robot mount T3 with A7 MIG Gun 500-g
3
1
4
2
1. Cover ring
2. 2 set screws
3. Robot mount
4. O-ring
Serious injuries can be caused by parts articulating rapidly. When cleaning with
compressed air, wear suitable protective clothing – in particular, safety goggles.
Proceed as follows:
1. Clean the robot mount (3) with compressed air.
2. Turn the cover ring (1) to the right until the stop, and remove it.
3. Check the O-ring (4) for wear, and replace it if necessary.
4. Clean the bores of the set screws (2) with compressed air.
5. Check the set screws (2) for wear, and replace them if necessary.
6. Grease the O-rings (4) with sealing grease (included in the delivery).
7. Mount the set screws (2), O-ring (4), and cover ring (1).
14.2 Cleaning robot mount T3 with A7 MIG Gun 500-w
This section describes how to clean the T3 robot mount with A7 MIG Gun 500-w.
Figure 11: Cleaning robot mount T3 with A7 MIG Gun 500-w
1
8 7
2 5
36
4
1. Set screw, M3×3
2. 2 compression springs
3. 2 O-rings, 7×1.5
4. 4 O-rings, 3.5×1.5
5. 2 compression sleeves
6. 2 balls
7. Robot mount
8. Gas duct
Serious injuries can be caused by parts articulating rapidly. When cleaning with
compressed air, wear suitable protective clothing – in particular, safety goggles.
Proceed as follows:
1. Clean the robot mount (7) with compressed air.
2. Grease the O-rings (3) with sealing grease (included in the delivery).
3. Mount the O-rings (3 and 4) on the compression sleeves (5).
4. Mount the balls (6), compression springs (2), and compression sleeves (5).
5. Detach the set screw (1) and gas duct (8), and check them, replacing if necessary.
6. Attach the set screw (1) and gas duct.