Operation Manual

15
Robot Gun Mount T3© Kemppi Oy 2016 1712
OPERATING MANUAL
12. OPERATION
The device may only be operated by qualied personnel.
Because the robot mount is integrated into the gun’s welding process, the operation
steps are performed after the relevant gun has been installed.
Please observe the operating instructions for the A7 MIG Gun 500-g or the A7 MIG Gun
500-w welding guns, as appropriate.
13. UNMOUNTING
Unmounting may only be carried out by specialist personnel. Please make sure that
the shutdown procedures for all components mounted in the welding system are strictly
observed before removal from operation begins.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
The details of removal from operation depend on the model of welding gun. Please
observe the operating instructions for the A7 MIG Gun 500-g or the A7 MIG Gun 500-w
welding guns, as appropriate.
14. MAINTENANCE AND CLEANING
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-
free operation.
Once a month, thoroughly clean the robot mount to remove all dirt and welding spatter.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
Electric shock
Dangerous voltages can be produced because of defective cables.
• Check all live cables and connections for proper installation.
• Replace any parts that have suered damage, deformation, or wear.
The maintenance intervals listed are recommended values and assume single-shift
operation.
• Maintenance and cleaning work may only be carried out by qualied and
trained specialists.
• Always wear your personal protective clothing when performing maintenance
and cleaning work.
• When replacing the liquid-cooled A7 MIG Gun 500-w hose assemblies, make
sure that any coolant residues are removed from the robot mount.
• The maintenance intervals listed are recommended values and assume single-
shift operation.