Operation Manual

14
Robot Gun Mount T3© Kemppi Oy 2016 1712
OPERATING MANUAL
11.6 Mounting the wire liner
This section describes how to equip the cable assembly
with a wire liner.
The new unused wire liner has to be shortened to the
actual length of the hose assembly.
For handling the wire liner, please observe the enclosed
wire guide mounting instructions.
Figure 9: Mounting the wire liner
3
6
1
4
2
5
1. Wire liner
2. Cable assembly
3. Contact tip
4. Insulation sheathing
5. Fastening nut
6. O-ring
Proceed as follows:
1. Lay out the cable assembly (2) straight.
2. Introduce the wire liner (1) through the cable
assembly (2) into the contact tip (2), all the way.
3. Check the excess length x of the wire liner (1), and
remove the wire liner (1).
4. Reduce the excess length x + 10 mm from the front.
5. Remove 300 mm of the insulation sheathing (4)
from the wire liner on the gun side.
6. Remove the burr formed by the shortening
operation at the wire liner (1).
7. Mount the wire liner (1) with excess length (10 mm
maximum) in the cable assembly (2).
8. Mount the wire liner (1) in the cable assembly (2),
and screw the nut (5) in.
9. Make sure that the O-ring (6)
• has been greased with sealing grease
(included in the delivery)
• has been mounted on the compression
sleeves