Operation Manual

16
Robot Gun Mount T2, T4© Kemppi Oy 2017 1712
OPERATING MANUAL
17. REMOVING THE MOUNT
This section describes how to remove robot mount T2.
Unmounting may only be carried out by specialist personnel. Please make sure that
the shutdown procedures are strictly observed before the unmounting work begins.
Ensure this also for the components integrated into the welding system.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
See also Chapter 13.
Proceed as follows:
1. Remove the parts to be disconnected:
3
6
1
4
7
2
5
8910111213
14
17.1 Disposal
For disposal, the locally applicable regulations, laws, provisions, standards, and guidelines
must be observed. For the welding torch system to be properly disposed of, it must be
unmounted rst.
17.2 Materials
This product consists for the most part of plastics, steel, and non-ferrous metals. Steel
and non-ferrous metals can be melted down, so iron materials are almost innitely
recyclable. The plastic materials used are marked in preparation for appropriate sorting
of the materials for later recycling.
17.3 Consumables
Oils, greases, and cleaning agents must not contaminate the ground or enter the
sewer system. These materials must be stored, transported, and disposed of in suitable
containers. Please observe the relevant local regulations and the disposal instructions
on the safety data sheets supplied by the manufacturer of the consumables. Also,
contaminated cleaning tools (brushes, rags, etc.) must be disposed of in accordance with
the information provided by the manufacturer of the consumables.
17.4 Packaging
The shipping packaging has been reduced to a minimum. Packaging materials are always
selected with attention to their possible recyclability.
1. Gun neck
2. Gun segment holder upper part
3. Dowel screw, 8 H7
4. Helix cable
5. Robot Gun Mount T2
6. Robot ange
7. Robot
8. Cylinder-head screw
9. Cylinder-head screws, M4×55
(6 pcs.)
10. Feather key
11. Gun segment holder lower part
12. Clamping ring
13. Cylinder-head screw, M8
14. M8 nut with washer