Operation Manual

61
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
5.2.6 I/O device errors
Code Description Severity Measures
201 INPUT 1 ERROR
Input 1 reported an error.
Error In addition to an ordinary input signal function, each input of
the I/O device can be congured to report an error or a warning
when the input status changes. The warning is just a notication
from an event - it does not prevent the operation of the welding
system. After clearing its cause, the warning state can be cleared.
The error stops welding and prevents operation of the welding
system until the situation is cleared and the error state is reset.
Both warnings and errors are recorded into the logbook.
See the A7 MIG Welder Integration guide for more information on
the input conguration.
202 INPUT 2 ERROR
Input 2 reported an error.
Error
203 INPUT 3 ERROR
Input 3 reported an error.
Error
204 INPUT 4 ERROR
Input 4 reported an error.
Error
205 INPUT 5 ERROR
Input 5 reported an error.
Error
206 INPUT 6 ERROR
Input 6 reported an error.
Error
207 INPUT 7 ERROR
Input 7 reported an error.
Error
208 INPUT 8 ERROR
Input 8 reported an error.
Error
209 INPUT 1 WARNING
Input 1 reported a warning.
Warning
210 INPUT 2 WARNING
Input 2 reported a warning.
Warning
211 INPUT 3 WARNING
Input 3 reported a warning.
Warning
212 INPUT 4 WARNING
Input 4 reported a warning.
Warning
213 INPUT 5 WARNING
Input 5 reported a warning.
Warning
214 INPUT 6 WARNING
Input 6 reported a warning.
Warning
215 INPUT 7 WARNING
Input 7 reported a warning.
Warning
216 INPUT 8 WARNING
Input 8 reported a warning.
Warning