Operation Manual

23
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
7/22 License menu
License code Enter a license code
manually:
• Up and down arrows are
used to select the code
number index.
• Control knob is used to
select the code number
(0-255).
• ENTER soft button is used
to activate the license code
after all numbers have
been entered.
License timers Check the remaining license
time of the time-based Wise
features.
8/22 Weld data delay 1 - 60 s 20 s Specify how long the Weld
Data is displayed after
welding stops. Weld Data
display can be closed by
turning the control knob or
pressing any button.
9/22 Display delay 1 - 20 10 Specify how long any
textual information (like
”Settings saved”) is displayed
on the screen. This is an
approximate time value and
the actual delay may vary
depending on the system
load.
10/22 Pre gas time 0.0 - 9.9 s,
CURVE
CURVE Override the pre gas time of
the welding curve, or let the
system use the curve value.
11/22 Post gas time 0.0 - 9.9 s,
CURVE
CURVE Override the post gas time of
the welding curve, or let the
system use the curve value.
12/22 Control * USER, PANEL,
REMOTE, GUN
USER Select which remote control
is used, or let the user choose
the remote control freely.
13/22 RemoteAutoRecog * ON, OFF ON Set the automatic
recognition of the remote
control unit on and o.
14/22 MIG CurrentDisp ON, OFF OFF Set the MIG current display
on and o. When the MIG
current display is o, the
wire feed speed is displayed
instead.
15/22 WFMotorWarnLev 1.5 - 5.0 A 3.5 A Set the warning level of
the wire feeding motor
current. The setting aects
how sensitively the system
detects issues in the wire
feeding system.
16/22 WF end step ON, OFF OFF Set the wire feeding end
step on and o. When the
setting is on, the ller wire
steps forward at the end of
the welding cycle. Otherwise
the ller wire remains in the
position where it was driven
during the welding cycle.
17/22 AutoWireInch * ON, OFF ON Set the automatic
SuperSnake wire inch
feature on and o. When the
setting is on, the ller wire is
driven automatically to the
SuperSnake by pressing the
wire inch button.