Operation Manual
15
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
4.2.1 Button functions
Power button
You can log OFF the current user by pressing on the power
button for approximately 5 seconds. The user identication
system has to be on and a user logged in for this function.
If the user identication system is o, the long press has
no eect.
Pressing this button anywhere in the menu returns to the
memory channel information display. Possible unsaved
changes are lost.
Memory channel selector
There are up to 200 memory channels available in the
system starting from number 0 and ending to number
199. The plus and minus buttons can be used to navigate
between the memory channels in the information display.
If the selected channel is empty, a soft button with text
NEW is shown allowing direct entering to a channel editor.
MENU entry button
Enter the main menu by pressing this button.
Up/down arrows
Navigate in the menus up and down by pressing these
buttons.
Control knob
Adjust values and settings of menu parameters by turning
the control knob.
Menu shortcut keys
Press the F1 to view additional information on the current
memory channel. Multiple presses show more information
pages. Pressing this button in the menu returns to the
channel information display.
Press the F2 to log a user in when the user identication
system is turned on and all users are logged o. Pressing
this button when a user has logged in redirects you to the
user settings menu. If the Key Lock feature is in use, a long
press (over 4 seconds) locks and unlocks the Setup panel.
Press the F3 to select another wire feeder. The selection is
allowed if there are multiple wire feeders connected into
the welding system.
Soft key buttons
The function of the soft key buttons depends on the
current menu location and the operation being performed
in that location. The function is indicated by a text in the
LCD display just above the buttons, for example BACK,
EXIT, SELECT, OK, SAVE or NEW.