Operation Manual
12
A7 MIG Welder© Kemppi Oy 2018 1824
OPERATING MANUAL
Figure 3.14 Robot mount T3
The robot mount Type 3 is a gun seat without integrated
collision protection. The collision protection or the switch-
o of the robot is only possible via the robot control.
For assembly and installation of the A7 MIG guns, see A7
MIG Gun 500-g Operation manual, A7 MIG Gun 500-w
Operation manual and A7 MIG Welder Integration guide.
For compatibility and selection table, see the separate
A7 MIG Gun 500-g Operation manual and A7 MIG Gun 500-
w Operation manual.
3.6 Cooling unit
A7 Cooler
1
3
2
5
4
6
7
Figure 3.15 Cooling unit
1. Test switch
2. Filling hole (in the side plate)
3. Overheat control indicator
4. Power supply cable
5. Control cable
6. Coolant return connector
7. Coolant output connector
The cooling unit is designed for automatic and manual welding equipment and to
be used for cooling of the liquid-cooled welding gun. See the A7 Cooler Operating
manual for more information on the installation.
This unit is equipped with a lter and a ow switch in the return channel to ensure
uninterrupted cooling operation. The operation is controlled by software. See the A7
MIG Welder Integration guide for system conguration options.