Operation Manual

22
A5 TIG Orbital System 75© Kemppi Oy 2016 1615
OPERATING MANUAL
3.6 Equipment stop
To stop weld head and controller operation at any time:
1. Press the Stop button on the weld head control
panel, or
2. Press the large red EQUIPMENT STOP button on
the controller unit. This is a locking switch that
disconnects power from the controller. The control
circuits remain powered.
The EQUIPMENT STOP button on the controller unit
needs to be released before the unit can be used.
6. To complete the installation after download, press
Equipment Stop.
7. Remove the stick.
8. To release Equipment Stop, rotate it slightly and
pull up.
The software has been updated and the A5 TIG Orbital
System 75 is ready for use.
If the weld head software is to be updated, repeat this
procedure. Start by pressing the weld head icon.
3.7 Updating software
To check for software revisions:
1. Check the version displayed on the splash screen
by pressing the Kemppi logo in the upper left
corner of the Home screen.
2. Display shows controller software revision as
well as weld head revision, if the weld head is
connected.
A
To update software:
1. Use the USB port to load new software. The weld
head does not have to be connected unless it is the
weld head software that is to be updated.
2. Press the Kemppi logo on the Home screen.
3. Press the controller icon.
4. Insert the memory stick into the USB port of the
controller unit.
5. The screen indicates that software transfer is in
progress.