Operation Manual

18
A5 TIG Orbital System 75© Kemppi Oy 2016 1615
OPERATING MANUAL
Check appears to indicate that calibration has been
successfully completed.
If an error occurred during calibration, an error screen of
below type appears.
7. Exit the screen by pressing Check Mark and repeat
the sequence.
3.5.8 Selecting power source
1. Press the power source icon.
2. Select your power source from the list.
3. After pressing the power source icon the correct
control panel setting is displayed on the screen.
Power Source Trigger logic must be set to 2T (remote
standard) mode. However, the terminology within the
industry is not standardized.
3.5.9 Pulsed/non-pulsed welding
Select Pulsed/Non-Pulsed welding.
Pulsed Current Non-Pulsed Current
These alternate at each push of the button.