Operation Manual
3
A3 MIG Welder© Kemppi Oy 2018 1826
INTEGRATION GUIDE
1. INTRODUCTION
The A3 MIG Welder is a complete welding system for robotic welding applications.
This guide, together with the A3 MIG Welder operating manual, instructs you on how to
set up the system and perform the necessary cable connections and setup conguration
to get the system running.
Important notes
Items in the manual that require particular attention for minimizing damage and harm
are indicated with the symbols below. Read these sections carefully, and follow their
instructions.
Note: A note item gives the user a useful piece of information.
Caution: Caution items describe a situation that may result in damage to the equipment
or system.
Warning: Warnings describe a potentially dangerous situation. If not avoided, it will
result in personal harm or fatal injury.
Disclaimer
While every eort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specication of the product described, at any time,
without notice. Do not copy, record, reproduce, or transmit the contents of this guide
without prior permission from Kemppi.
2. INTEGRATION STEP BY STEP
To ensure safe and ecient integration of the welding system, follow these simple
steps:
1. INSTALL HARDWARE
• Make sure that all the components are OK.
• Attach all required equipment to the robot and to the
welding cell.
• Make all required cable connections.
2. CONFIGURE THE SYSTEM
• Congure the sensors and devices.
• Congure the eldbus.
• Power up the system.
• Congure the power source.
After completion of these steps, the system is ready for welding.
For detailed instructions on each of the steps, consult the corresponding section of
this document.