User Manual
THE DEEPER VIEW 9
Master/Output Section
In the Output Section you find all settings that control the physical audio outputs of the Profiler. You can
set individual volumes and route dierent signals individually to several outputs. The whole Output section
settings can be stored as a local preset, in the way you have learned already with the stomps and eects.
Note: The volume level settings are not stored with the local output presets, as switching the presets
would result in dangerous volume jumps.
Note: The settings of the Output section are not stored per rig, but stay global settings. In the Profilers ter-
minology: They are locked and cannot be unlocked.
Volumes and Volume Link
In the first page of the Output menu you find individual volumes for dierent physical outputs.
Note: You will not find a volume for the Spdif output, because it is a good habit to keep the digital Spdif
signal at its full level.
When you press the correspondent button on top of the display, you can link or unlink the respective vol-
ume to the Master Volume Knob. Any volume that is linked will be controlled by the Master Volume Knob,
without having to enter the Output menu again. You can link more than one volume to the Master Volume
Knob. If you turn Master Volume, these volumes are adjusted relatively to each other. All Volumes can still
be controlled individually by the soft knobs in the Output menu.
An obvious live application is to unlink the Main Output that is going to the main mixing desk of the venue.
Now you can change the volume of your Monitor signal or Headphone while the important main signal re-
mains unchanged.
Note: When more than one volume is linked to the Master Volume Knob, and the highest volume has
reached its maximum, then softer volumes cannot be increased any more by the Master Volume Knob. This
is a necessary technical rule to preserve the relative volume settings. If one volume stays too soft, then
change the setting individually in the display.