User Manual

PEDALS, PROGRAM CHANGES AND MIDI 57

 Note: the Proﬁling Ampliﬁer expects so-called “momentary” switches. These close the contact when you

step on them, and open it again when you lift your foot o. Channel switches for tube amps are not com-

patible with the KPA, as they use a latching mechanism instead.

Double Switches

The “Double Switch” selection is special: it can take a double or stereo switch from a single jack, so the

other jack is still free to use an expression pedal, or even another stereo switch.

In BROWSE MODE, the default assignment for “Double Switch” is Rig Up/Down. In Proﬁler Mode, it switch-

es from Kemper Amp to Reference Amp, and in the Store Menu, it will navigate the cursor to the left or

right. Alternatively, you can create your own “Double Switch” set-up by assigning any combination of the

available functions with the Soft Knobs.

Operation of a MIDI remote pedal

The Kemper Proﬁling Ampliﬁer connects easily to MIDI remote pedals from any manufacturer. Simply con-

nect your MIDI pedal to the MIDI IN jack of the KPA. There are three groups of MIDI messages that the KPA

can receive:

 Program Change

You can assign up to 128 program change numbers to your Rigs. The assignment is done in the SYSTEM

Menu/Program # Assign.