User Manual

KEMPER PROFILING AMPLIFIER54
Quick On this page you can determine the function of the QUICK button using the soft
knob “Quick Function”. This function allows you to use the QUICK button as a
shortcut to get to often used pages like “MIDI Settings” or “Browse Snapshots”
directly.
Rig Autoload On the same page you can use the soft button “Rig Autoload” to activate the Rig
Autoload function. This will automatically load a rig when it is selected in the rig
browser. The “Load” button in the rig browser will disappear when you activate
“Rig Autoload”.
Direct Edit The soft button “Direct Edit” will change the behavior of the section buttons
on the front panel. Instead of holding them briefly to enter the edit page for
a module or section, clicking on a button like AMPLIFIER, EQ or STOMP will
immediately display the edit screen.
Pedal Settings
On this system you can determine the kind of pedals that you want to use with the KPA with the soft
knobs and initialize them using the soft buttons. You will find more detailed information regarding pedals a
little bit further down in this manual.
MIDI Settings
On the next system page you can assign up to 128 MIDI program change numbers to rigs in the KPA to
switch between them by using an external MIDI pedal or by sending program changes from your com-
puter.
To do so, first select the rig you want to assign a program change number to and then press the SYSTEM
button. Navigate to the MIDI Settings page using the right page button, select a desired PrgChg slot using
the soft knob labeled “MIDI PrgChg#” and then press the soft button labeled “Assign”. Use the soft button
labeled “Unassign” to unassign a rig.
On the next page you can set the MIDI Channel that you want to use for communication between the KPA
and your other MIDI devices using the soft knob labeled MIDI Global Channel.