User Manual

SYSTEM 53
System
Press this button to access the global settings pages. Global settings do not change when you switch to
another rig.
LCD/HW Setup
On this page you can control the settings for the display and adjust the “Line Frequency” parameter. The
soft button labeled “Factory Rigs” will allow you to reload all the Factory rigs that came with the KPA.
Please note that your own rigs and profiles will not be overwritten. Press the soft button labeled “Startup
Dialog” to enter the Startup Dialog setup where you can enter your name and the current time and date.
This will be used by the KPA as the default Rig author name and to automatically timestamp any rig that
you create. This dialog did appear automatically the first time you started the KPA but in case you skipped
that step you can enter the information on this page.
Contrast The soft knob “Contrast” lets you set the contrast of the display. Adjust this
settings if you find the display hard to read under certain circumstances.
Brightness The soft knob “Brightness” controls the brightness of the display.
White Balance The soft knob “White Balance” adjusts the white balance of the display.
Line Frequency The soft knob “Line Frequency” lets you choose between a Line frequency of
50 or 60 Hz. The Noise Gate will use this setting to eliminate ground hum which
frequency is based on the physical location the KPA is being used at. Auto 50 or
Auto 60 will detect the Line frequency automatically while 50 or 60 can be used
if the automatic detection fails.
Brightness Using the page buttons you can navigate to the next page where you can set the
brightness separately for the color LEDs, the buttons and the LED collars and the
TAP button using the soft knobs.