User Manual

STOMP SECTION 27
O The pedal has no eect. The eect will be static, and can still be controlled by the
“Manual” soft knob.
Touch Uses the picking strength to control the eect, as described below.
On The Wah pedal is active. Control the impact of the pedal by the “Range” parameter.
Bypass @ Stop The Wah pedal is active. The stomp eect will be smoothly faded in when you start
moving the pedal, and smoothly faded out when you stop moving it.
Bypass @ Heel The Wah pedal is active. The stomp eect will smoothly fade out when you park
the pedal at the heel position.
Bypass @ Toe The Wah pedal is active. The stomp eect will smoothly fade out when you park
the pedal at the toe position.
 Touch
This mode resembles the classic Touch Wah behavior, where the depth of modulation is controlled by the
picking strength, and is available for all Wah eects. As with the regular Wah pedal, the “Range” param-
eter controls the intensity of the Touch eect.
When “Touch” is engaged, three more parameters are added to the eect, that you can access by pressing
the right Page button:
Touch Attack Controls the speed of reaction to the guitar attack.
Touch Release Determines the rate at which the eect falls back to its rest position.
Touch Boost Use this to extend the scale of the Range parameter. You will also notice, when
“Range” is low, but “Touch Boost” is high, you can push the intensity up to a ceiling,
that can be useful for certain eects.