User Manual

KEMPER PROFILING AMPLIFIER22

Stomp Section

The STOMPS section holds 4 Stomp modules called A, B, C and D which are placed in the signal ﬂow be-

fore the ampliﬁer stack. The modules represent your choice of virtual stomp boxes. The STOMPS section is

all mono because the ampliﬁer will only accept a mono signal. In dierence to that, the X and MOD stomps

in the EFFECT section work in stereo, if desired.

The Stomp modules oer you all kinds of eects which are identiﬁed by eight dierent colors that are

easy to memorize:

Distortion Red

Wah Orange

Chorus Blue

Phaser & Flanger Purple

Compressor Cyan

EQ Yellow

Delay Green

Eect Loop White

Press and hold any STOMP button to bring it into focus. If the stomp is active the display will change its

color to match the eect. The soft knobs will display the parameters available to edit.

There are two ways to choose a new eect: either turn the BROWSE knob to select a new local eect pre-

set, or turn TYPE, to change the basic algorithm of the module.

Many parameters are common to several dierent eects, such as “Mix”, “Volume”, “Rate” – to name just

a few. When you change the algorithm of an eect using the TYPE knob, the values of these mutual pa-

rameters will not be changed. This allows for eect types that share a mutual parameter set to keep these

values. For example, you can create a great ﬂanger eect with your desired rate and depth setting. Then