User Manual

MAKING CONNECTIONS 45

The above assumes that you are miking the speaker cabinet connected to your reference amp. If you are

taking a direct, cabinet-simulated output either from the amp itself, or from a speaker load box such as the

Hughes & Kettner Redbox or Palmer boxes, you can connect the line-out from a load box directly to the

RETURN INPUT of your KPA.

The reference amp that you want to proﬁle has to be connected to the KPA in such a way that only the

KPA will send and receive the signals. This eectively turns the KPA into a monitoring device.

Avoid any other connections that might lead to confusion and end up corrupting the results. For example,

if you want to use several microphones with your reference amp you should route the signals of these

microphones to a subgroup of your mixer, and then route the output of that subgroup directly to the PRO-

FILING INPUT. You can use the EQ and phase switches on the mixer to optimize the mix. Make sure that

the signal is only routed to the KPA and isn’t duplicated at the main outs of the mixer.

KEMPER PROFILING AMPLIFIER

Input

Direct Out / Send

Main Outs

Return

Output

Guitar In

Reference Amp

Cabinet