User Manual

Output Section 95
Output Section
In the Output Section, you can find all settings that control the physical audio outputs of the PROFILER. These
settings are spread across several pages – use the <PAGE> buttons to move between them.
You can set individual volumes and route different signals individually to several outputs. The settings of the entire
Output Section can be stored as an output preset, in the same way you have already learned with the effects.
Technically, it is possible to lock the Output Section like any other module or section. However, as the settings in the
Output Section are never stored as part of a Rig, locking it has no practical value – it is global by design, and
therefore nearly always locked.
✓ The volume level settings are not stored with the output presets, as switching the presets could result in dangerous
volume jumps.
✓ The settings of the Output Section are not stored per Rig but stay as global settings. In PROFILER terminology: they
are locked and cannot be unlocked.
Output Volumes and Output Volume Link
Within the Output Section you can find individual volumes for different physical outputs.
When you press the correspondent "Link" soft button in "Output Volumes" or "Output AddOns", you can link, or
unlink, the respective volume to the MASTER VOLUME knob. Any linked volumes will be controlled by the MASTER
VOLUME knob, without having to enter the Output Section again. You can link more than one volume to Master
Volume – all linked volumes will be adjusted relatively to each other. All output volumes can still be controlled
individually by soft knobs in the Output Section. An obvious live application is to unlink the MAIN OUTPUT
connected to the main mixing desk of the venue – this means you can now change the volume of your monitor
signal, or headphones, while the all-important main signal remains unchanged.