User Manual
Table Of Contents
- Legal Notice
- Table of Contents
- About this Main Manual
- Rigs and Signal Chain
- Front Panel Controls Head, PowerHead, Rack, and PowerRack
- Chicken Head Knob (1)
- INPUT Button (2)
- INPUT LED (2)
- Module and Section Buttons (3)
- OUTPUT/MASTER Button (4)
- OUTPUT LED (4)
- NOISE GATE Knob (5)
- Direct Control Knobs (6)
- MASTER VOLUME Knob (7)
- TAP Button (8)
- SYSTEM Button (9)
- RIG Button (10)
- QUICK Button (11)
- TYPE Knob (12)
- BROWSE Knob (13)
- Soft Buttons and Soft Knobs (14)
- ON/OFF Button (15)
- LOCK Button (16)
- COPY and PASTE Buttons (17)
- STORE Button (18)
- UNDO and REDO Buttons (19)
- EXIT Button (20)
Buttons (21) - RIG Navigation Cross (22)
- HEADPHONE Output (23)
- GAIN Knob (24)
- RIG VOLUME Knob (25)
- Front INPUT (26)
- USB (27)
- Back Panel Overview Head, PowerHead, Rack, and PowerRack
- Front Panel Controls Stage
- On/Off Button (1)
- Mode Select Buttons (2)
- INPUT Button (3)
- INPUT LED (3)
- Module and Section Buttons (4)
- OUTPUT/MASTER Button (5)
- OUTPUT LED (5)
- MASTER VOLUME Knob (6)
- SYSTEM Button (7)
- PEDALS Button (8)
- RIG Button (9)
- TYPE Knob (10)
- BROWSE Knob (11)
- Soft Buttons and Soft Knobs (12)
- MORPH Button (13)
- LOCK Button (14)
- EDIT Button (15)
- COPY and PASTE Buttons (N/A)
- STORE Button (16)
- Button (17)
Buttons (18) - GAIN Knob (19)
- Up/Down Buttons (20)
- Rig Buttons 1-5 (21)
- TAP Button (22)
- TUNER Button (23)
- Effect Buttons I-IIII (24)
- Looper (25)
- Back Panel Overview Stage
- Basic Setups
- Using the Tuner
- Rig Settings
- Working with Amplifier PROFILEs, Cabinet PROFILEs, Power Amps and Guitar Cabinets
- Separating Amps and Cabinets: CabDriver
- Browsing Amps or Cabinets
- Direct PROFILEs
- Direct Amp PROFILEs
- Cabinet Impulse Responses
- Merging Studio PROFILEs and Direct Amp PROFILEs
- Running a Guitar Speaker Cabinet from a Power Amplifier, “Monitor Cab Off”
- The Built-in Power Amplifier
- The Sound of Guitar Cabinets versus Mic'ed Speakers
- PURE CABINET
- Output Section
- Instrument Input and Reamping
- Expression Pedals and Foot Switches
- Stack Section
- Effects
- Wah Effects (Orange)
- Distortion (Red)
- Booster (Red)
- Shaper (Red)
- Equalizer (Yellow)
- Compressor (Cyan)
- Noise Gate (Cyan)
- Chorus (Blue)
- Phaser and Flanger (Purple)
- Pitch Shifter (White)
- Delay (Green)
- Delay Mix
- Mix Location Pre/Post
- Low Cut & High Cut
- Cut More
- To Tempo
- Delay Time & Delay Ratio
- Note Value
- Feedback
- Freeze
- Infinity
- Cross Feedback
- Reverse Mix
- Input Swell
- Smear
- Stereo
- Grit
- Stereo Modulation
- Flutter Intensity & Flutter Rate
- Single Delay
- Dual Delay
- Two Tap Delay
- Serial Two Tap Delay
- Rhythm Delay
- Quad Delay
- Legacy Delay
- Pitch Shifter Delay (Light Green)
- Reverb (Green)
- Effect Loop (Pink)
- System Settings
- Bass Players: Special Hints and Features
- Performance Mode
- PROFILER Remote
- MIDI
- Continuous Controllers
- Effect Switches
- Rig Change in Performance Mode
- Rig Change in Browser Mode
- MIDI Global Channel
- MIDI Clock
- Transmitting MIDI Commands to Two External Devices in Performance Mode
- Transmitting Pedal Controllers for Morphing, Wah, Volume, and Pitch to Two External Devices
- Transmitting User Interface to MIDI Global Channel
- NRPN
- Getting Organized
- Updates, Backups and Sharing Sounds
- PROFILING an Amp
- Trouble Shooting
- KEMPER PROFILER Specifications
- Dimensions
- Weight
- Analog Inputs PROFILER Head, PowerHead, Rack, and PowerRack
- Analog Inputs PROFILER Stage
- Analog Outputs PROFILER Head, PowerHead, Rack, and PowerRack
- Analog Outputs PROFILER Stage
- Power Amp PROFILER PowerHead and PROFILER PowerRack
- Control and Data Interfaces
- Digital Inputs and Outputs PROFILER Head, PowerHead, Rack, and PowerRack
- Digital Inputs and Outputs PROFILER Stage
- Electrical Requirements
- Environmental Requirements
- Electrical Approvals
Working with Amplifier PROFILEs, Cabinet PROFILEs, Power Amps and Guitar Cabinets 92
The Sound of Guitar Cabinets versus Mic'ed Speakers
This chapter is dedicated to guitar players who usually listen to their amps through a guitar cabinet and are not
familiar with the studio sound of a guitar cabinet captured by a microphone.
The guitar speaker is different from most other speaker types, as it is only capable of transmitting a limited frequency
response. Therefore, listening to music through one is not a good idea at all. For guitar playing, however, they are
essential - especially for distorted sounds, as they damp the harsh, high frequencies of the distortion. Their heavy
coloration of the lower frequency components is also hugely beneficial to the tone of an electric guitar.
To record the guitar sound through a guitar cabinet, or further amplify it for a live concert, you have no option but to
place one or more microphones in front of the speaker to capture the complete sound of the rig. The choice of
microphones, and also their positioning, will add even more flavor to the sound - this is certainly an art in itself, but
fortunately it is easy to learn.
The Studio PROFILEs in your browse pool are captured by the same way. Achieving an authentic sound is as easy
as connecting the MAIN OUTPUT to your mixing desk, whether it be in a studio, or in a live venue. This is one major
advantage of digital guitar amps - they capture the entire sound of the guitar cabinet and microphone in their digital
heart. No need to carry heavy guitar cabinets any more, or struggle to reproduce a certain microphone position.
There is another drawback that can be avoided on stage or in the rehearsal room: guitar cabinets have a focused
sound, meaning the high frequencies are loudest when you listen on the axis of the speakers. Conversely, they are
damped when you listen off-axis. Every speaker suffers from this effect to some degree, but guitar cabinets are
particularly bad. The closer you stand to the guitar cabinet, the more off-axis and out-of-focus you get, because your
ears are positioned much higher than the axis of the speakers. This means that if you want to sit well in the mix
onstage, you will tend to need quite a loud volume. Unfortunately, the victims in all this will be your fellow musicians
and your audience in a small venue, who listen much closer to the axis of your speaker. Remember - they don’t hear
what you hear. This might well be the reason why guitarists are often accused of playing too loud - it’s all down to the
focus.
The problem here, is that guitar players who don’t play regularly in studios or live venues often tend to struggle when
listening to the Studio PROFILEs of the PROFILER through monitor speakers or headphones. Some say the original
sound from the guitar cabinet is the “real” amp sound, while mic'ing the cabinet gives it an artificial flavor. Listening
to a mic'ed amp through full-range speakers is a different experience to that of sitting in the room, listening to the
guitar cabinet directly, and the difference is especially obvious when you listen to the amp without being