User Manual

Front Panel Controls Head, PowerHead, Rack, and PowerRack 30
All the settings in the Output Section are global (or “locked”) and will therefore not be saved with the Rig. However,
as with all other modules, you can save the settings for the Output Section as presets. This allows you to create
output presets with adjustments tailored to specific venues, studios or rehearsal rooms.
✓ Read more about the settings in the Output Section and special applications in the chapter Output Section; there is
also a tutorial video specifically about the Output Section and recording setups, which can be found on:
www.kemper-amps.com/video
OUTPUT LED (4)
The PROFILER performs soft clipping and is very forgiving in terms of amplitude clipping, so here is no need to
panic if the OUTPUT LED flashes red occasionally. Typically, you might experience this with clean sounds. In such
cases you could either decrease Rig Volume or another Volume in the Rig e. g. Amplifier Volume, or perhaps
consider enhancing your clean Rig with a Compressor effect.
NOISE GATE Knob (5)
This knob controls the Noise Gate, which eliminates the noise and hum of your guitar in a very smart way. Turn the
NOISE GATE knob to the right until noise and hum have disappeared; do not turn it beyond that point, as this might
alter the sound of your guitar. When set to the appropriate position, you will notice that noise and hum are
eliminated, even when the strings are still sounding. There is no need for an additional release control as found in
classic noise gates. The Noise Gate settings can be stored as part of a Rig.
Like "Clean Sens", the Noise Gate setting is part of the Input Section and is stored with the Rig. It is also stored as
part of any input preset. When the Input Section is locked, the noise gate is locked as well.