User Manual

MIDI 264
✓ As soon as you select MIDI THRU to transmit MIDI commands by Slot the PROFILER will stop forwarding incoming
MIDI data to the MIDI THRU.
Transmitting Pedal Controllers for Morphing, Wah, Volume, and Pitch
to Two External Devices
The four pedal controllers for Morphing (control change #11), Wah (control change #1), Volume (control change #7),
and Pitch (control change #4) can also be sent via MIDI to those two external devices configured on the “Perform
Mode: MIDI” page in System Settings. This works even if the expression pedals are connected to the PROFILER
directly, or to the PROFILER Remote. To enable this feature please select the “Pedals to MIDI” option in System
Settings.
Transmitting User Interface to MIDI Global Channel
If “UI to MIDI” is selected in System Settings, nearly all parameter changes within the PROFILER user interface, and
the connected PROFILER Remote, will be forwarded through the MIDI OUT. You could, for instance, create a daisy
chain of PROFILER units, all following whichever commands you enter on the leading PROFILER, or connected
Remote, including any Rig or Slot changes.
This stream of MIDI commands will be sent on whichever channel has been selected to be the MIDI Global Channel.
If this is set to “Omni”, MIDI channel 1 will be used for “UI to MIDI”.
✓ If you intend to transmit other MIDI commands in Performance Mode, or if you want to transmit pedal controllers
simultaneously with “UI to MIDI”, make sure that you either select different MIDI channels or different MIDI outputs to
avoid logical interferences. For example, if you’re sending “UI to MIDI” via MIDI channel 1, select MIDI channel 2 and
3 for the two external devices.