User Manual

MIDI 262
While program changes are required to initiate the Rig load, bank select MSB and LSB are redundant. You don’t
need to send bank select MSB because Performance Mode always assumes value “0”. Bank select LSB is not
required if you navigate within the same MIDI bank.
These two MIDI control change numbers are associated with MIDI bank select:
#0
Bank select MSB (always value 0)
#32
Bank select LSB (values 0-4)
Rig Change in Browser Mode
You can assign up to 128 MIDI program change numbers to Rigs in your browse pool. These assignments are set in
the System Settings on page “Browser Mode PrgChg”.
To assign a program change number to a Rig, first load the Rig in the Browser Mode. Then press the SYSTEM
button. Navigate to the page “Browser Mode PrgChg” using the PAGE buttons.
Select a desired program change number using soft knob “MIDI PrgChg#” and then press the soft button “Assign”.
Use the soft button labeled “Unassign” to erase assignments.
Without leaving this page you can use the RIG navigation cross to load other Rigs from your browse pool and
perform more assignments.
Received MIDI program changes are indicated by a small “#” icon and control changes by a small knob icon on the
home screens in both Browser and Performance Mode. If bi-directional MIDI communication is established, this is
reflected by a “two arrows” icon.
Instead of using MIDI program changes, you can use control changes (#48-54) to load Slots in Performance Mode
and Rigs in Browser Mode. Please refer to the tables in the previous paragraph.