User Manual

MIDI 259
Rig Change in Performance Mode
Performance Mode offers 125 Performances, each with five Slots, allowing to store up to 625 Rigs independently
from your browse pool. A typical application for a Performance would be to organize all the sounds you need for a
song in one place.
All Slots in Performance Mode have fixed MIDI assignments. To accommodate for varying remote controller
capabilities there are two methods available to address and load a Rig in any Slot.
With the “relative” method, you can step or scroll through the list of Performances using MIDI control changes #48
and #49. Ideally these two controllers should be assigned to the “Bank” buttons of your remote controller. MIDI
control change #50-#54 will load the Rigs stored in Slots 1-5 within the Performance selected. The global parameter
“Performance Load” determines what happens after you have sent control change #48/49 to step or scroll to another
Performance. By default, “Performance Load” is set to “Pending” and the PROFILER waits until you send one of the
control changes #50-#54; thereby finally selecting your Slot. If “Performance Load” is set to “Slot 1” or “Keep Slot”,
the PROFILER will load the corresponding Slot as soon as any Performance is selected.
#47
Values 0-124 preload Performance 1-125. One of the CCs #50-54 then loads one of the
Slots, if this Slot is enabled.
#48
In Performance Mode: Value 1 steps one Performance up and starts scrolling after a while.
Value 0 stops scrolling, or steps only one Performance up.
In Browser Mode value 0 steps one Rig up, value 1 steps five Rigs up, value 2 steps to first
Rig of next higher bank of five.
#49
In Performance Mode: Value 1 steps one Performance up and starts scrolling after a while.
Value 0 stops scrolling, or steps only one Performance up.
In Browser Mode value 0 steps one Rig up, value 1 steps five Rigs up, value 2 steps to last
Rig of next lower bank of five.
#50
Loads Slot 1 of present Performance and in Browser Mode Rig 1 of current bank.