User Manual

PROFILER Remote 251
Advanced Looper Functions
The Looper offers several expanded functionalities. All these functions are accessible by holding the respective
Looper Button, rather than just pressing it shortly. As before, we will explain the advanced functions by following the
buttons on the Remote:
Holding
There are three different situations where holding this button can make sense.
As an alternative to the standard recording method, you can hold this button down to
determine the length of the initial recording. The looper will continue recording until you
release the button, at which point the loop end is set, and playback of the recorded loop
begins.
The Record / Playback / Overdub Button has a potential drawback: when the loop end
gets set, it automatically turns to playback mode at the same time. A subsequent
overdub, immediately after the initial recording, cannot be done by simply pressing the
button. However, it is possible by holding it: Start the initial recording by pressing shortly.
For loop end, and subsequent overdub, press and hold the button. The loop will instantly
be repeated, and your playing will be overdubbed for as long as you hold the button.
For subsequent overdubs, rather than pressing "Record / Playback / Overdub" quickly to
change modes, hold it for the overdub and release it for playback.
Holding
For erasing the current loop, instead of pressing the Stop Button three times, you can
hold it for two seconds. That's the way many other loopers handle the erase of the loop.
Holding
When you hold the Reverse Button for a second, the Looper will enter "back & forth"
mode. That means it will change the direction automatically at the beginning and end of
the loop. By holding it again for a second, it will revert to the regular reverse, or forward,
mode.
Holding
½
Holding this button will turn Half Speed to a momentary event, lasting only if you hold the
button