User Manual

PROFILER Remote 247
Here's a brief description of all Looper Buttons:
LOOPER
Activates the Looper and toggles the functions of following six buttons between “normal” and
“Looper”.
Record / Playback / Overdub
Stop / Erase: press 3 time to erase the current loop
Cancels, or reactivates, most recent overdub
Trigger: triggers the loop when in stop mode, or retriggers the loop when in play mode
Reverse: plays the loop in the reverse
½
Half speed: records and plays back the loop in half speed; doubles the recording time
By setting the Looper Location switch in the respective System Settings page, you can choose the position of the
Looper in the signal flow.
 Looper Location Input
The Looper is placed right after the instrument input. It records the pure guitar signal and plays it back before the
effect modules. When you change Rigs during the playback of the loop, you'll hear the playback processed by the
different Rigs. However, when you perform overdubs, then all overdubs will be run through the same Rig, as if
multiple guitars were played through the same amp at the same time.