User Manual

Performance Mode 237
Performance Mode
Turn the chicken head knob into the PERFORM position or hold the PERFORM button of the PROFILER Stage for a
moment.
Performance Mode is a powerful tool that allows to organize Rigs in “Performances” that can be accessed
independently from your browse pool. A total of 125 Performances are available, each of which can hold up to five
Rigs in logical locations called "Slots". You could, for example, use a Performance to store the sounds dedicated to
the intro, verse, refrain, bridge, and solo of a song, and switch between them using a foot controller.
Setting up Performances
You can navigate through the 125 Performances using the up and down buttons of the RIG navigation cross on the
front panel of PROFILER Head, PowerHead, Rack and PowerRack. Use the left and right buttons or the <PAGE>
buttons to select a Slot within a Performance.
On the PROFILER Stage, use the TYPE knob or the Up/Down Buttons to navigate through the Performances and
the <PAGE> buttons or the Rig Buttons to select one of the five Slots.
By default, all Slots are pre-loaded with a default Rig, which happens to be based on the ancient Rig “CK 0”. The
Performance itself has a default name. Once you have selected the Slot, choose the Rig you want to assign to it via
BROWSE. The Rig will be copied and displayed in the highlighted Slot. At this point, we should mention that any
edits will be lost if you select another Performance without storing it first.
If you require fewer than five different Rigs in one Performance, you could disable Slots 2 to 5 selectively. This way
you can block Slots and prevent accidental loading via foot controller. Only Slot 1 is requisite.
Rigs contained in Slots of Performances are stored in a dedicated memory area, so you can tweak them
independently from their parent Rigs in your browse pool. Editing Rigs in Performance Mode is basically the same as