User Manual

Rigs and Signal Chain 21
Any edits of a Rig are indicated by an “E” on the right side of the home pages in Browser and Performance Mode
and are temporary until you store the Rig.
If you changed a parameter setting, but want to return to the previous value, you can use the UNDO button on the
left side of the display. It will always revert your most recent action. The REDO button will revert the action of the
UNDO button – this is a great way to compare two settings. UNDO and REDO buttons are not available at the
PROFILER Stage™.
In Browser Mode, you can select the desired Rig using the buttons of the RIG navigation cross – this can be found
on the right side of the front panel of all PROFILER variants except PROFILER Stage. Press left/right to advance in
single steps, or up/down to jump to the next group. Another way to scroll Rigs is by using the BROWSE knob located
above the right-hand side of the display. The advantage of using the BROWSE knob method is that it allows you to
view eight Rigs at once - the RIG navigation cross can then be used to move the cursor around the list. The
BROWSE knob on the PROFILER Stage also features a push/select function which you can use to load a Rig as
soon as you scroll to it.
You can limit the selection of Rigs with the TYPE-knob (“Views”) and change the sequence of Rigs by using the soft
button labelled Sorting to sort them by date or author, and then load the selected Rig with the “Load” soft button.
Once you have found a Rig that you like, you have immediately control over the Gain, which displays its current
value on the LED collar around the dedicated knob. You can also use the soft knobs below the display to change the
tone of the amplifier in the Rig.
Effect Modules
Each Rig contains eight effect modules. The first four labeled “A, B, C, and D”, are all mono, and are applied before
the signal reaches the stack section. These are best suited to stomp boxes like distortions or wah effects. Once the
signal has passed through the amplifier and virtual cabinet, you can add four stereo effects in the modules labelled
“X, MOD, DLY, and REV”. The list of available effect types is identical across all effect modules.
The DLY and REV modules have a predefined position and purpose. In the PROFILER Head/PowerHead™ and
Rack/PowerRack™ models, the DLY module has dedicated knobs for Delay Feedback and Delay Mix, and the REV
module has dedicated knobs for Reverb Time and Reverb Mix.