User Manual

Delay (Green) 187
✓ Delay Feedback can be controlled with the dedicated knob in the upper half of the panel, so long as the effect is
placed in the DLY module.
Above the “Feedback” soft knob you will find the “Freeze” soft button and, on several delay types, an “Infinity” soft
button. Both buttons are so-called "Action & Freeze" functions. These can be assigned to the Effect Buttons of the
PROFILER Remote for performance applications. To assign them, hold the desired Effect Button on the Remote with
your foot, while you press the respective soft button above the display on your PROFILER. To undo the assignment,
repeat the same action.
 Freeze
"Freeze" is an Action & Freeze function, which turns the delay into an endless loop. The delay track will be repeated
without losing or gaining level, and without sound degradation. The input of the delay is cut, so no further signal is
added to the delay, allowing you to play along to the loop.
 Infinity
When you activate "Infinity", another Action & Freeze function, Feedback will be switched from the regular value
(between 0 and 100%) to the Infinity feedback value that spans from 100% to 200% and is separately controllable.
This feedback lets the delay repeats build up instead of decaying – this pushes them deeper into tape saturation,
where they will repeat indefinitely, as the sound degrades over time. To ensure a pleasing, lush result, you should
adjust the sound of the tape saturation with the High Cut and Low Cut parameters. Set Mix Location to "Post" if you
wish to control the signal level of the saturated delay by the Mix control.
In contrast to the Freeze function, Infinity Feedback still lets you add more signal to the delay, creating
intermodulation with the repeated signal.
✓ The “Freeze” and “Infinity” soft buttons can both be assigned to one of the Effects Buttons of the PROFILER
Remote. Step and hold the desired Effects Button (I to IIII) while you press the "Freeze" soft button or the "Infinity"
soft button.