User Manual

Expression Pedals and Foot Switches 131
Volume Pedal Function
In difference to the Wah and Pitch Pedal functions, the Volume Pedal function does not have its own effect type, as
this would allocate an effect module every time you wanted to use the pedal. Instead, you will find two parameters
for the Volume Pedal in Rig Settings.
 Volume Pedal Location
Selects the location of the Volume Pedal in the signal flow:
Off
The Volume Pedal has no effect.
Input
Directly before the A module
Pre Stack
Right after the D module. At this position, you control the gain of the amplifier.
Post Stack
Right before the X module. At this position, you control the overall volume of the sound, but
delay and reverb tails will still decay naturally, when you swell down the pedal.
Output
Right after the REV module. At this position, you control the overall volume of the sound,
including reverb and delay tails that can instantly be attenuated.
 Volume Pedal Range
This is a bipolar parameter. In the middle position, the Volume Pedal has no effect. When you set the Range more to
the left, you determine the minimum volume at heel-position, while the maximum volume at toe-position stays the
same. At the minimum position, the pedal performs the swell from zero level, just as you would expect from an
analog volume pedal. As you turn “Volume Pedal Range” towards the right half, the Volume Pedal turns from an