User Manual

Expression Pedals and Foot Switches 128
Connecting a PROFILER Switch
Connect the KEMPER PROFILER Switch using a TRS cable to one of the PEDAL inputs and select the “PROFILER
Switch” mode on the corresponding "Pedal" page in “Pedal Settings” of your PROFILER Stage or “System Settings”
of any other PROFILER variant. Assign your preferred switching functions to the A and B switches. Then hold
“Calibrate” and trigger each switch once. Release “Calibrate”. Done!
Single and Dual Switches of Other Brands
The PROFILER requires so-called “momentary” switches. Channel switches for tube amplifiers are not compatible
with the PROFILER, as they use a latching mechanism that would only trigger their assigned switching function
every other hit. Single switches are connected via a TS cable, and dual switches via a TRS cable.
Select “Mono Switch” or “Dual Switch” Mode on the corresponding "Pedal" page in Pedal Settings of PROFILER
Stage or System Settings of all other PROFILER variants and assign a switching function with the soft knob labeled
“Switch Tip”. If “Dual Switch” is selected, another switching function can be assigned with soft knob labeled “Switch
Ring”. Please set polarity according to the kind of the switches used: select “Normal” for a switch that is closed in idle
state, and “Inverse” for a switch which is open in idle state. Don’t forget to hold “Calibrate” and trigger each switch
once.
✓ You can find a tutorial video focused on technical conditions, and all other aspects of connecting expression pedals
and switches to PROFILER or Remote at: www.kemper-amps.com/video