User Manual

Output Section 100
• You can exploit this when PROFILING amplifiers: When you set the Output Source of DIRECT OUTPUT or SEND 1
to “Off”, you can mute the reference amplifier by simply switching from PROFILER Mode to Browser Mode. Back in
PROFILER Mode, your reference amp will play again.
• For all PROFILER models, except Stage, the reference amp can also be muted while you stay in PROFILER Mode.
Simply press the ON/OFF button while you listen to the PROFILE (setting “KEMPER Amp”) to mute the reference
amp. This way you can listen to the pure PROFILE through your monitor speakers without having your reference
amp play along. Be aware, however, that a valid A/B comparison between the original amp and the residual
PROFILE is only possible when your reference amp is playing, even when you listen to the PROFILE, because
muting the reference amp will change the acoustic environment. Use the DIRECT OUTPUT, SEND 1 or any other
output at setting “Git…” for connecting an external instrument tuner.
• The Output Source for the DIRECT OUTPUT of PROFILER Head, Rack, PowerHead and PowerRack is only active
if no analog Effects Loop (e. g. Loop Stereo) is active, and “Monitor Stereo” isn’t activated.
• If you are going to mix the DIRECT OUTPUT or SEND 1 with the MAIN OUTPUT, select “Git+Processing” or “Git
Studio” as the source for the DIRECT OUTPUT/SEND 1 in the Output Section. This will allow you to avoid different
latencies between processed and unprocessed signals. Do not use "Git Analog" in this case.
The MONITOR OUTPUT allows you to run the amp sound without virtual guitar cabinet, while other outputs still
contain the virtual guitar cabinet. Engage “Monitor Cab Off” to switch off the guitar cabinet. Any Output Source can
be applied to the MONITOR OUTPUT with “Monitor Cab Off”. Of course, the “Git…” settings remain unaffected by
“Monitor Cab Off”. Read more about the monitor features in the chapter MONITOR OUTPUT. Be aware that the
signal from the MONITOR OUTPUT is also shared in order to feed the built-in power amplifier of the PowerHead and
PowerRack.
• When Source is set to “DLY/REV wet” for a stereo output, it will deliver only the wet stereo effect signal of delay and
reverb effects from the DLY and REV modules. If you set the source of the DIRECT OUTPUT to “Stack” or “Mod”,
which is the complementary dry signal, then you can send your amp signal to the front mixing desk through three
cables. For PROFILER Stage, you could use one of the two SEND jacks for this application. Your front mixer can
now mix the effect signal to the dry signal, according to the actual room ambience of the venue. This method is