Installation Guide

7
INSTALLATION
Preparation
1. Unpack refrigerator, removing foam packing.
2. Lay the refrigerator down on its back on a piece of
soft packing material. Use caution and two people
while laying the appliance down.
3. Remove top door stopper if fitted (Figure 1).
4. Place adjustable rollers in the fully retracted position
by screwing height adjusting screw fully anti-
clockwise (Figure 2). Do not remove the adjusting nut
completely.
5. Stand upright.
Figure 1
Figure 2
Plastic roller nut
INSTALLATION OF 120˚ HINGE
Please follow the instructions below to install the
120º hinge.
120º hinge
mounting plate
Attach mounting plate with 120º hinge and tighten
the screw.
120º hinge
screw
mounting plate
Use screws provided with the hinge to attach the
cupboard door to the cupboard.
screws
Use 120º hinge to attach the cupboard door to the cabinet.
cabinet
37mm
cupboard door
This dimension is typically 37mm
(from centre line of mounting plate
to the cupboard cabinet edge)