Installation Guide

13
SECURING THE REFRIGERATOR IN
THE CUPBOARD
NOTE: When attaching all screws to cupboard, first drill
a 2mm pilot hole in the correct position. This will allow
easy hand insertion of self tapping screw.
Now that the refrigerator is correctly positioned:
1. Screw in top hinge bracket to the cupboard wall
using 4 cupboard screws provided. This will secure
the top of the refrigerator (Figure 12).
2. Screw down both foot brackets to cupboard floor
with 2 cupboard screws. This will secure the bottom
of the refrigerator (Figure 13.)
Figure 12
Fridge
Figure 13
ATTACHING SLIDE-BAR TO THE
CUPBOARD DOOR
1. Fully open cupboard door (120°).
2. Open refrigerator door until it rests against the
cupboard door.
3. Position slide-bar in slide-housing so that all three
holes are visible when both doors are fully open
(120°). This position is typically 230mm from the edge
of the slide housing (Figure 14).
Figure 14
120º
refrigerator door
cupboard door
125mm
slide bar
Whilst slide-bar is still in housing:
4. Rotate slide-bar to uppermost alignment, mark a line
on cupboard door (Figure 15).
Figure 15